How To Connect Ground Wire In Light Fixture. When electricity flows through a wiring system, there is always the potential of causing an electrical shock.
To avoid this risk and to protect people from getting hurt, a safety ground wire can be used.
Depending on how the grounding rod is installed, once a grounded object comes into physical contact with it all the electricity running along that wire will be distributed throughout the grounding system in your home and finally into the ground via the Ground Rod.
How To Connect Ground Wire In Light Fixture
The purpose of this article is to explain how to connect the ground wire to a light fixture.
Step 1
It is safe to start by uncovering the ground wire of the light fixture. Make sure the power is off! Don’t try and work on it when it’s on or you might get a shock from the exposed wires.
Once you have identified where the wires are, then you can remove the light fixture so that you can find out which wires go to different parts of it.
Step 2
This should be near the ground. Link it to a green wire running along the middle of the fixture. The ground wire is unattached.
From this point, you may take use a connector to attach yet another wire going to your ground in order for it to get properly introduced and bonded with your fixture’s electrical system.
Step 3
When it’s time to connect the ground wires to the light fixture, know how the fixture works once it’s installed. Light fixtures are grounded when the two wires are interconnected.
The right way to connect them is essential and careful. In order to make this happen, you’re going to use a connector of some sort in order for them both to create a connection that will ensure the current can flow as intended.
You will have a safety net in place while simultaneously ensuring all systems are functioning with no problems at all.
Step 4
Last, test the light fixture. Turning the power source on is advisable but not necessary as testing a light fixture has nothing to do with a circuit’s wiring.
All that you need to check is whether or not the lighting system flickers or gives off a clear light. This indicates that your lighting system is in good working order.
FAQs
Ground wires can be attached to mounting screws?
Take the screw of your mounting bracket and thread it into a green ground loop that is attached to the wall.
Tighten this loop and your light fixture will be secured to the wall. If there is no green wire, simply cap off the end with a wire nut.
Do I have to cover the ground wire?
Most of the time, ground wires are not connected to electricity, and they are usually tied together with exposed wires.
You do not have to worry about getting shocked when touching the grounding wire since it doesn’t have much electric current flowing through it.
Ground wires, however, are not completely safe from electrical surges that could cause electrons to flow through them.
Related Guides