How to cut granite countertop. Granite countertop installation is not a do-it-yourself project as the sections are large and cumbersome. If granite tile countertops are found to be more attractive.
However, it’s an easy process to install these with minimal expertise needed. And regardless of which option is preferred to go with, you will still have to be able to trim the granite so that they fit properly because they are extremely hard materials.
This task requires some special equipment such as a wet saw or diamond blade disc cutter.
How to cut granite countertop
Granite might just look like a solid rock. But when you have the right tools, it’s a breeze even with the precautions and safety gear involved.
When using a diamond-cut blade on a circular saw, it’s possible to cut through granite quite precisely and cleanly. As long as you have the right safety gear and are using these tools properly, working on this project can be fun.
Wear safety gear
Always start by getting your safety gear on before you begin (goggles and a mask to keep the dust at bay!).
Painter’s tape can be applied
The very first step you should take when measuring out where you will make your cuts is to mark the area with painter’s tape so you can measure with a ruler.
Don’t forget to apply the tape directly over the place where you will be cutting and make sure it stays in place, otherwise, your measurements won’t be accurate.
Look closely at your newly marked-off space by using a ruler on either side of the painter’s tape or wherever else it touches.
Take measurements of the granite
Ensure the granite piece you’re going to cut is measured properly and marked accurately before proceeding. Use a straight edge to mark a line where your measurements require it be trimmed.
Prepare the saw before using it
Be sure to find a saw that’s sharp and made for the job at hand. For instance, whichever type you choose, whether wet or dry, your tool will need to have an extra-strong blade made from diamond. Without it, the granite slab won’t be able to get through the stone.
Start cutting the granite
Marble and granite can be difficult to work with, especially when you’re starting out as a stone cutter. It’s important to take it slow while sawing or else you could mess up your project and have to restart the whole thing from scratch.
Protect yourself by making sure that you are standing to the side of where you’re cutting in order to avoid being harmed if something should happen.
Although some people prefer using one hand while holding the stone steady with their other hand, using two hands is also recommended in order to stay safe as well as give yourself more precision when handling delicate materials.
Use water to spray the granite
To make sure your cutting job goes smoothly, have a helper spray water on the granite as you are making the cut. A wet saw is best for removing granite because of its power to cut through just about anything with little resistance.
Always keep your eyes on the saw
When sawing to make a cut, always hold onto the saw firmly and keep a steady eye on the blade. Turning away from the blade in a careless manner can result in you getting hurt as well as making an imperfect cut down the line.
Reviewing Your Cut
When your cut is satisfactory, it’s time to check out how you measure up against a professional. If you feel confident that your cut was sufficient, congrats.
However, if you need some extra practice before proceeding, try repeating the process by re-marking and re-cutting with practicing cutting off smaller parts of excess paint in small increments until you feel comfortable moving on.
Clean and polish the granite
Polish the stone with a suitable instrument and do any fine cutting which is necessary. If you want the polished face of the stone to be exposed, ensure that your cutting edges are at angles that allow light to reflect off of them, again using a diamond-tipped grinding wheel.
How To Cut Granite Countertop