How to raise chlorine level in pool. Raise the level of chlorine in your pool by adding it informs that will make it free available chlorine. Because this is free available.
Your body does not need to work hard to absorb the chlorine, but instead can enjoy many benefits associated with smelling the pleasant odor of this wonderful chemical compound.
Free available chlorine does not need to be combined with other disinfecting chemicals because it is already safe for human use.
How to raise chlorine level in pool
Raising chlorine levels in a pool can be quite a bit easier than lowering them. The easiest way to go about raising your pool’s chlorine level is by adding more chlorine-based chemicals.
Chlorine tablets and powder are an effective means of boosting your levels, as well as concentrated liquid shock treatments or even plain water (which contains a slight amount of natural chlorine).
Test the FAC level
The FAC (Total Alkalinity) is the level of alkaline or base in a pool. The optimum range for it lies between 80 ppm and 120 ppm, however, you shouldn’t go below 60 ppm since it could damage your pool.
If the water of your pool is cloudy or green, you may have to increase its chlorine levels to about 10 ppm or more as per instructions for shocking pools and let them decrease till they reach 5-5.5 ppm level before swimming in them.
You can add chemicals directly by dumping the required amount of algae control which will raise the concentration to a value of between 1 and 3 ppm which should be sufficient for swimming.
Determine the pool’s volume
For example, let’s say the width of the pool is 8 feet and the length is 15 feet. Let’s also say that an average depth of water is 3.5 feet in a regular-sized in-ground pool.
First, we would need to know how many gallons are in a cubic foot (we’re not sure if you know what this conversion ratio is).
If you’re looking for the numbers 7.5 gallons/1 cubic feet then I’m sure you’ll find them somewhere on the internet.
Once you have figured out how many gallons fit into one foot of water, then multiply the number of inches for the length multiplied by the number of inches for the width to equal 750gal divided by 12in = 62.5gal * 4 ft = 628 gals.
Follow the product instructions
Be sure to follow the instructions on the product you are using because after all, how else would you know which products to use.
How much of each product to add into your pool, and at what time? We don’t want you to add too much or too little.
Backwash your pool filter
Backwash (Remove the dirt from) your pool filter, vacuum any sediment from the bottom of the pool to Waste.
This will help ensure that a higher percentage of chlorine will remain available in the water rather than breaking down into its elements in a chlorination process.
Adding the chlorine
To prevent the chlorine from being degraded by sunlight, add it to a swimming pool in the late afternoon or early evening.
Chlorine naturally breaks down when exposed to sunlight so adding it at night will provide optimal amounts needed for all of your swimmers.
If the water has a low concentration of cyanuric acid (only added to pools as a pH stabilizer), then Dichlor or trichlor tablets might be used.
Pour the amount of chemical needed
Pour the needed amount of chemicals into the sides of a new pool while circling it in a circular motion. Avoid pouring it directly into the skimmer.
After adding chlorine or pool shock: whichever is necessary, it’s okay to run the circulation pump for about eight hours.
Related Guides